Signet Ring Fit and Care: Bespoke Silver Guide

Quick answer

Choose a bespoke signet ring silver size that slides over your knuckle with slight resistance but doesn't spin freely, and care for it by storing it dry and cleaning with a soft cloth. These two habits prevent the most common fit and tarnish problems.

How to size and care for your signet ring

1. Measure your finger at the right time: Measure your dominant hand's finger at the end of the day when it's largest, using a ring sizer or a ring that fits well on that finger. Wrap the sizer snugly but not tight. Common mistake: measuring in the morning or after caffeine, when fingers are smaller, leading to a ring that's too tight later. Write down the measurement and recheck it once in the afternoon before ordering.
2. Check knuckle clearance: Slide the sizer or ring over your knuckle. It should pass with slight resistance. If it won't go over, size up. If it slips over with no resistance, size down. Common mistake: ignoring the knuckle and choosing a size that only fits the base of the finger, which makes the ring hard to remove. Your knuckle is the narrowest point the ring must pass, so always test removal as well as insertion.
3. Wear it for an hour before deciding: Put the ring on and wear it for at least an hour during normal activity—typing, driving, making a fist. The Bespoke Signet Ring (silver) has a flat face, so check that the face doesn't dig into neighboring fingers. Common mistake: deciding based on a quick try-on in the store without moving your hand. If you feel pressure points or the ring spins, exchange for a different size before wearing it outside.
4. Clean after each wear: Wipe the ring with a soft, dry cloth after taking it off to remove oils and sweat. For deeper cleaning, wash with mild soap and lukewarm water, then dry completely with a lint-free cloth. Common mistake: using harsh chemicals or ultrasonic cleaners, which can damage silver or any set stones. Never store the ring damp; moisture speeds tarnish.
5. Store it dry and separate: Keep the ring in a dry pouch or a lined jewelry box, away from direct sunlight and humidity. Store it separately from other pieces to avoid scratches. Common mistake: leaving it in the bathroom or on a windowsill, where steam and sun accelerate tarnish. A small silica gel packet in your jewelry box helps absorb moisture.
6. Handle tarnish early: If you notice a slight dullness, polish with a silver polishing cloth using gentle back-and-forth strokes. For heavier tarnish, use a silver dip according to package directions, then rinse and dry thoroughly. Common mistake: scrubbing hard with an abrasive pad, which removes the surface layer and can dull the finish. Tarnish is easier to remove when you treat it at the first sign of yellowing.

Product facts

• Bespoke Signet Ring (silver): The Bespoke Signet Ring (silver) is a versatile ring that can be worn solo or layered with other favorites. Its simple design makes it easy to pair with existing rings, but layering can affect fit on adjacent fingers, so test the ring with your usual stack before committing to a size.